Make sure the shirt is saturated all the way around.Ĭhoose the areas where you want the circle or bull’s-eyes to appear. Put on your rubber gloves and choose a different dye for each section between rubber bands, making sure the ink is fully absorbed through each layer of pleating. Take your rubber bands and place them evenly across the pleated shirt log using about five to eight bands. Don your rubber gloves, choose your dye and saturate each quadrant.įold the shirt from the bottom up into small pleats until the shirt in the shape of a long, thin log. Take several rubber bands and tie into quadrants. Continue to crumple the shirt in a random way while making a flattened disc shape. Pull little pieces of the shirt up by pinching your fingers to bring as much of the shirt up to where the dye will be applied. Lay the shirt flat then take your hand and twist, turn and crumple it while keeping the shirt flat. Make sure to do the back of the shirt, too, so you have a uniform look. Put on your rubber gloves and squirt at least three different dye colors onto the wedges formed by the bands. Wrap the disc with three to six rubber bands in a crisscross overlap pattern which will give you six wedges or quadrants of fabric. Pull the shirt from the center stomach area and twist/swirl in one direction so the entire shirt forms a flattened disc shape that looks a rose. When it’s dry, you are ready to wear and enjoy your classic shirt! Tie-dye patterns Do not combine the shirts with any other clothing for that initial wash and dry in case any extra dye bleeds. Then remove the rubber bands, rinse again, then machine wash and dry the shirts on the hottest setting allowed on the shirt tag. Squeeze ink onto the sections per kit instructions or per the pattern you’ve decided to follow - or freestyle it! Once you’ve finished dying, place each shirt in a sealed plastic bag for 24 hours to allow the ink to set and the colors to become vibrant.Īfter 24 hours, put on a pair of rubber gloves, remove the shirt from the bag and rinse it in cold water (without removing the rubber bands) until the water runs clear of the dye. Twist the shirt and wrap with rubber bands to secure it in your desired pattern. Spray the shirt with water to dampen it, then choose your pattern from the list of four below or come up with your own. If you bought powered or liquid dye, prepare it according to package instructions and put the ink into the squirt bottles. If you bought a kit, set up the inks in the bottles according to the tie-dye instructions. Cover your work space with a plastic tablecloth (or set this up outside). If you have purchased a new T-shirt, machine wash and dry it first, but don’t use fabric softener or a dryer sheet, to avoid leaving any kind of residue on the fabric that might repel the ink. A spray bottle of water (helpful to dampen shirts before applying ink).These items, if not using a tie-dye kit:.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |